Chamfer and filler are used to design edges where surfaces meet and ease sharp corners and edges. The fillet creates a smooth curve, whereas a chamfer changes the slope of the edge. In this way, they can minimize stress concentration as they transmit forces across large surface areas. This helps create durable parts. In this […]
The die-casting process is mainly leveraged by most manufacturers because of its ability to produce a complete metal part that doesn’t need further assembly. However, there are minimal chances that the metal is produced as a finished product. In some cases, only a few surface finishing options have to be made, but more often than
Leakers primarily refer to defective castings that leak molten liquid or entrapped air/gas. It concerns the leakproof segment of die casts without any potential leakage. However, this is more like an improvised form of shrinkage-based defects in die casting metal alloys. Many experts and manufacturers consider these leakers as a manifestation of the casting solidification.
